Delivery Scope; Intended Use; Technical Data; Declaration Of Conformity - Bosch GWS Professional 7-100 Originalbetriebsanleitung

OBJ_BUCH-1188-003.book Page 15 Tuesday, August 13, 2013 2:49 PM
Symbol Meaning
High speed
Switching On
Switching Off
On/Off switch lock-on
Releasing the lock-on function of the
On/Off switch
Prohibited action
Permitted action
Next step of action
P Rated power input
1
P Output power
2
n Rated speed
n Speed control adjustment
v
l = Grinder spindle length
d
1
d = Grinder spindle diameter
l
1
D = Max. grinding disc diameter
d
2
d = Inner disc diameter
D
2
Speed preselection
Additional information
Surface grinding
Grinding/sanding with sanding sheet
Weight according to EPTA-Procedure
1
01/2003 with vibration-damping auxil-
iary handle
Weight according to EPTA-Procedure
2
01/2003 with standard-auxiliary handle
Symbol for protection class II (com-
/II
pletely insulated)
L Sound power level
wA
L Sound pressure level
pA
K Uncertainty
a Vibration total value
h
Bosch Power Tools

Delivery Scope

Angle grinder, protection guard, auxiliary handle.
Special protection guards, application tools and other acces-
sories shown or described are not part of the standard deliv-
ery scope.
A complete overview of accessories can be found in our ac-
cessories program.

Intended Use

The machine is intended for roughing metal, stone and ceram-
ic materials and for drilling tiles.
For cutting with bonded abrasives, a special cutting guard
(accessory) must be used.
When cutting in stone, provide for sufficient dust extraction.
Together with the hand guard (accessory), the machine can
be used for brushing and grinding/sanding with elastic sand-
ing plates.
The machine is suitable only for working without water.

Technical Data

The technical data of the machine are listed in the table on
page 242.
The values given are valid for a nominal voltage [U] of 230 V.
For different voltages and models for specific countries,
these values can vary.

Declaration of Conformity

We declare under our sole responsibility that the product de-
scribed under "Technical Data" is in conformity with the fol-
lowing standards or standardization documents: EN 60745
according to the provisions of the directives 2011/65/EU,
2004/108/EC, 2006/42/EC.
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
D-70745 Leinfelden-Echterdingen
Henk Becker Helmut Heinzelmann
Executive Vice President Head of Product Certification
Engineering PT/ETM9
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
14.08.2013

Noise/Vibration Information

The measured values of the machine are listed in the table on
page 242.
Noise and vibrational values (vector sum of three directions)
determined according to EN 60745.
The vibration emission level given in this information sheet
has been measured in accordance with a standardised test
given in EN 60745 and may be used to compare one tool with
another. It may be used for a preliminary assessment of expo-
sure.
English | 15
1 609 92A 0EE | (13.8.13)