IKEA KYLSLAGEN Bedienungsanleitung Seite 18

ENGLISH
Problem
The compressor operates
continually.
The compressor does not
start immediately after
pressing Fast Freezing, or
after the change of the tem-
perature.
Water flows inside the re-
frigerator.
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The Fast Freezing function
is switched on.
This is normal, no error has
occurred.
The water outlet is clog-
ged.
Food products prevent
water from flowing into the
water collector.
The melting water outlet is
not connected to the evap-
orative tray above the
compressor.
The Fast Freezing function
is switched on.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
The food products temper-
ature is too high.
Many food products were
inserted at the same time.
The door has been
opened too often.
The Fast Freezing function
is switched on.
Solution
Refer to "Fast Freezing func-
tion".
The compressor starts after
some time.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Attach the melting water outlet
to the evaporative tray.
Switch off Fast Freezing func-
tion manually, or wait until the
function resets automatically
to set the temperature. Refer
to "Fast Freezing function".
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products temper-
ature decrease to room tem-
perature before storage.
Insert less food products at the
same time.
Open the door only if necessa-
ry.
Refer to "Fast Freezing func-
tion".
18