Additional Information; Troubleshooting; Error Messages - Pioneer DEH-2500UI Bedienungsanleitung

Section
Installation
03
2 Secure the mounting sleeve by using a
screwdriver to bend the metal tabs (90°) into
place.
1
2
1 Dashboard
2 Mounting sleeve
# Make sure that the unit is installed securely in
place. An unstable installation may cause skipping
or other malfunctions.
DIN Rear-mount
1 Determine the appropriate position
where the holes on the bracket and the side
of the unit match.
2 Tighten two screws on each side.
3
1
2
1 Tapping screw (5 mm × 8 mm)
2 Mounting bracket
3 Dashboard or console
14
En
Removing the unit
1 Remove the trim ring.
1 Trim ring
2 Notched tab
! Releasing the front panel allows easier ac-
cess to the trim ring.
! When reattaching the trim ring, point the
side with the notched tab down.
2 Insert the supplied extraction keys into
both sides of the unit until they click into
place.
3 Pull the unit out of the dashboard.
Removing and re-attaching the front
panel
You can remove the front panel to protect your
unit from theft.
Press the detach button and push the front
panel upward and pull it toward you.
For details, refer to Removing the front panel to
protect your unit from theft and Re-attaching the
front panel on page 4.

Additional information

Troubleshooting

Symptom Cause Action
The display You did not per- Perform operation
automatically form any opera- again.
returns to the tion within
ordinary dis- about 30 sec-
play. onds.
The repeat Depending on Select the repeat
play range the repeat play play range again.
changes un- range, the se-
expectedly. lected range
may change
when another
folder or track is
being selected
or during fast
forwarding/re-
versing.
A subfolder is Subfolders can- Select another re-
not played not be played peat play range.
back. when FLD (fold-
er repeat) is se-
lected.
NO XXXX ap- There is no em- Switch the display
pears when a bedded text in- or play another
display is formation. track/file.
changed (NO
TITLE, for ex-
ample).
The unit is You are using a Move electrical
malfunction- device, such as devices that may
ing. a cellular be causing the in-
There is inter- phone, that terference away
ference. transmits elec- from the unit.
tric waves near
the unit.

Error messages

When you contact your dealer or your nearest
Pioneer Service Center, be sure to note the error
message.
Common
Message Cause Action
AMP ERROR Unit fails to op- Check the speak-
erate or speaker er connection. If
connection is the message fails
incorrect; pro- to disappear even
tective circuit is after the engine is
activated. switched off/on,
contact your deal-
er or an author-
ized Pioneer
Service Station
for assistance.
CD player
Message Cause Action
ERROR-07, The disc is dirty. Clean the disc.
11, 12, 17, 30
The disc is Replace the disc.
scratched.
ERROR-07,
There is an elec- Turn the ignition
10, 11, 12,
trical or me- switch OFF and
15, 17, 30, chanical error. back ON, or
A0 switch to a differ-
ent source, then
back to the CD
player.
ERROR-15 The inserted Replace the disc.
disc is blank.
ERROR-23
Unsupported Replace the disc.
CD format.