TFA 30.3054.10 Bedienungsanleitung Seite 11

TFA_No. 30.3054_Anleitung
KLIMA-MONITOR - Wireless Thermo-Hygrometer
• To connect more transmitters, repeat steps 1 to 5. The correct switch position
for the transmitters 1-8 can be found in the table. 3 transmitters are includ-
ed, the basic station is expandable to a total of 8 transmitters (optional).
Switch (D 6)
1 2
down down
down down
down up
down up
up down
up down
up up
up up
— —
— —
6.2 Installation of the basic station
• Open the battery compartment of the basic station and insert four new bat-
teries 1.5 V AAA, polarity as illustrated.
• All LCD segments will be displayed for about a few seconds.
• Close the battery compartment again.
• The measurements of the installed transmitters will be transmitted to the
basic station. The radio-controlled reception symbol appears.
• If the reception is successful, on the display appear the temperature and
humidity of the respective transmitter, the temperature trend symbol and
the symbol of the comfort level.
• The radio-controlled reception symbol disappears.
• In the display section 4 appears automatically the measured values of the
internal sensor.
• If the values are not received from a channel or if no transmitter is installed,
"- -" appears on the display. Check the batteries and try it again. Check if
there is any source of interference.
• You can start the initialization manually.
20
27.10.2014 17:04 Uhr Seite 11
Function
3 4
down — channel 1
up — channel 2
down — channel 3
up — channel 4
down — channel 5
up — channel 6
down — channel 7
up — channel 8
— down °F
— up °C
KLIMA-MONITOR - Wireless Thermo-Hygrometer
• Press the CHANNEL / + button until the arrow appears on the desired chan-
nel. If you want to search for all installed transmitters, select the internal
sensor (IN).
• Press and hold the CHANNEL / + button for three seconds.
• The radio-controlled reception symbol appears.
• The basic station will scan the measurements.
6.3 Additional transmitters
• If you have installed more than three transmitters, the measurements for
transmitter 4-8 appear on the display section 4.
• Press the CHANNEL / + button to select the display section 4. The arrow
appears on the corresponding display section.
• Press the CHANNEL / + button to change between the installed transmitters.
• Press the button again after showing the last installed transmitter, on the
display appears the circle symbol. On the display section 4 appear in
sequence, the values of the internal sensor and the fourth to eighth trans-
mitter. Press the button again to deactivate the function.
• On the display appear again the measured internal values.
6.4 Temperature display
• Press and hold the MIN/MAX / – button in normal mode to change between
°C (Celsius) or °F (Fahrenheit) as temperature unit.
6.5 Display of the temperature tendency
• The trend pointer on the display indicates if the temperature values are
increasing, steady or decreasing.
6.6 Comfort level
• On the display appears a friendly face (RH 45...65%), a neutral face (RH
< 45%) or sad face (RH > 65%) to indicate the comfort level of the climate.
RH < 45% RH 45...65%
dry comfortable
RH > 65%
wet
21