grabner Happy Cat Ultralight Handbuch Seite 32

MOtOr Bracket
► A bracket to carry an outboard motor can
be mounted instead of the rudder assem-
bly.
► Place the motor bracket back in position,
insert the bolt from above through the
frame element and secure by means of
the ring.
► The motor attaches to the brackets motor
retention panel.
atteNtiON: check secure seating of
the motor after approx 15 minutes of run.
the motor bracket is designed for a long
shaft outboard motor to a max. output of
2.2 kW /3 hp and max. weight of 17 kg.
32
Seat cuShiONS
► Inflate the seat cushions (max. opera-
ting pressure 0.3 bar)
► The air pressure hardness can be varied
infinitely to suit.
► Position the seat cushions on the side
frame elements overlapping the gap to
the float-tubes.
► Fasten seat cushions by means of the
straps to the rear of the trampoline frame
and to the eye at the shroud.
SuN aWNiNg
► When using the cat as a bathing plat-
form, the awning provides welcome
shade.
► For details of mounting refer to the enc-
losed assembly instructions.
Other practical accessories
► Masthead float
► wide boat trolley
► boat cover
► wind gauge