Programming The Remote Control - THOMSON ROC 8505 Bedienungsanleitung

ROC8505_en 13/07/05
Note 2:To control 2 devices of the same type and same
make (2 Thomson video cassette recorders, 2 Thomson
satellite receivers, etc.) first make sure that these two
devices have been already adjusted to react to different
sub codes (A and B codes on Thomson devices).Then suc-
cessively program 2 mode keys using method D.
Programming
the remote control
Method A – Fast programming with
1-digit subcode
SETUP
TV: television set - DVD: DVD player - VCR: video cas-
sette recorder - SAT: satellite - CBL: cable - DVBT:
receiver (adaptor) for terrestrial digital television -
AMP:Amplifier - AUDIO: Hifi system - AUX: other devi-
ces.
OK
In principle, your set is ready for receiving the remote
control commands. Check your remote control for proper
functioning by performing the test described on page 3.
Method B – 3-digit codes Programming
SETUP
17:04 Page 2
OK
TV: television set - DVD: DVD player - VCR: video cas-
sette recorder - SAT: satellite - CBL: cable - DVBT:
receiver (adaptor) for terrestrial digital television -
AMP: Amplifier - AUDIO: Hifi system - AUX: other
devices.
In principle, your set is ready for receiving the remote
control commands.Check your remote control for proper
functioning by performing the test described on page 3.
Method C – Programming by means of
code retriever
SETUP
TV: television set - DVD: DVD player - VCR: video cas-
sette recorder - SAT: satellite - CBL: cable - DVBT:
receiver (adaptor) for terrestrial digital television -
AMP:Amplifier - AUDIO: Hifi system - AUX: other devi-
ces.
OK
In principle, your set is ready for receiving the remote
control commands. Check your remote control for proper
functioning by performing the test described on page 3.
2
OK