Information On Grilling And Combined Operation; Suitable Microwave Tableware; Operation Of The Device; Initial Operation - BOMANN MWG 2211 U CB Bedienungsanleitung

Information on Grilling and
Combined Operation
• As heat radiation is used during grilling and combined
operation, please use only heat-resistant tableware.
• When food is only being grilled, metal or aluminium
tableware may also be used -but not during combined or
microwave operation.
• Only the grill is suitable for COMBI operation.
• Do not place anything on top of the housing as this becomes
hot.
• Always leave the ventilation slits uncovered.
• Please use the grilling grid to move the food to be cooked
nearer to the heating element.

Suitable Microwave Tableware

• The ideal material for use in a microwave is transparent and
allows the microwave radiation to heat the food evenly.
• Round/oval dishes and plates are more suitable than rectan-
gular ones as the food in the corners may overcook.
CAUTION:
Danger of explosion from tightly sealed cookware.
• Open sealed containers before cooking or heating.
• Pierce plastic protective fi lms several times with a fork.
• Microwaves are not able to penetrate metal, so that no metal
vessels or plates should be used.
CAUTION:
Do not use any paper dishes made of recycled material as
these may contain small amounts of metal, which may result
in sparks or fi res.
The list below is intended to help you select suitable microwave
tableware:
Material
Heat-resistant glass
vessel
Non-heat-resistant
glass vessel
Heat-resistant ceramic
vessel/plate
Plastic vessels suitable
for microwave use
Kitchen roll
Metal tray
Grilling grid
Aluminium foil and foil
containers
*) Combination of microwave with grill.

Operation of the device

• Your selection by pressing buttons is confi rmed by a signal
tone. If not, you did not press properly.
05-MWG 2211 U CB.indd 41 05-MWG 2211 U CB.indd 41
Suitable for
microwave grill combination*
yes yes yes
no no no
yes yes yes
yes no no
yes no no
no yes no
no yes yes
no yes no
• Then an acoustic signal is heard when the rotary knob is
turned for the fi rst time.
• If you set a program but do not press the QUICK START/
START button within 5 minutes, the setting will be canceled.
The display will then show the current time again.
• When the door is open, the lights in the oven are on. If the
door is not closed after 10 minutes, the lights turn off.
• When starting a program, the remaining operating time will
be displayed. The countdown runs.
• 5 signal tones will indicate the end of the program.

Initial Operation

• After removing all the accessories from inside the oven,
unpack them and place the sliding ring in the middle.
• Position the glass plate on the drive axle in such a way that
it locks into the dents of the drive shafts and is lying fl at.
• Check the device for any visible damage, particularly in the
area of the door. If any damage is found, the machine must
not be used.
• In order to avoid interference to other machines when the
microwave oven is operated, do not place it in the direct
vicinity of other electronic devices.
• Remove any protective foils that may be adhered to the
housing.
• Insert the mains plug into a properly installed 230 V, 50 Hz
power socket.
CAUTION:
Do not remove any installed parts from inside the oven or from
inside the door!
NOTE:
If there are any oil or other residues from the manufacturing
process on the housing or heating element, smoke or odours
may initially be produced. This is normal and will not occur
after the oven has been used a few times.
The following procedure is strongly recommended:
• Turn the device to the grill function and allow it to run se-
veral times without any food inside (max. 5 minutes each
time).
Please ensure suffi cient ventilation.
•
Setting the clock
NOTE:
During the fi rst setting a signal tone will sound and the display
will show "0:00".
• Press the CLOCK/PRE-SET button. The "clock" symbol
lights up in the display. The fi rst digit fl ashing.
• Use the turning knob to set the desired hour.
• Press the CLOCK/PRE-SET button. The second digits will
be fl ashing.
• Use the turning knob to set the desired minutes.
• Press the CLOCK/PRE-SET button again to activate the
new time. The delimiter symbol ":" of the digital time will be
fl ashing on the display. The "clock" symbol goes off.
41
09.02.2010 14:15:07 Uhr 09.02.2010 14:15:07 Uhr