Herunterladen Inhalt Inhalt Diese Seite drucken

Information On Grilling And Combined Operation; Suitable Microwave Tableware; Operation Of The Device; Initial Operation - BOMANN MWG 2216 H EB Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für MWG 2216 H EB:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

4
Place the microwave oven in the cabinet and
pull the mains cable.
Fix the microwave oven using the long screw
(B).

Information on Grilling and Combined operation

As heat radiation is used during grilling and combined operation,
please use only heat-resistant tableware.
When food is only being grilled, metal or aluminium tableware may
also be used -but not during combined or microwave operation.
Always leave the ventilation slits uncovered.
Please use the grilling grid to move the food to be cooked nearer to
the heating element.

Suitable Microwave Tableware

The ideal material for use in a microwave is transparent and allows
the microwave radiation to heat the food evenly.
Round/oval dishes and plates are more suitable than rectangular
ones as the food in the corners may overcook.
CAUTIoN:
Danger of explosion from tightly sealed cookware.
Open sealed containers before cooking or heating.
Pierce plastic protective flms several times with a fork.
Microwaves are not able to penetrate metal, so that no metal ves-
sels or plates should be used.
CAUTIoN:
Do not use any paper dishes made of recycled material as these may
contain small amounts of metal, which may result in sparks or fires.
The list below is intended to help you select suitable microwave table-
ware:
20
Material
Heat-resistant glass vessel
Non-heat-resistant glass
vessel
Heat-resistant ceramic
vessel/plate
Plastic vessels suitable for
microwave use
Kitchen roll
Metal tray
Grilling grid
Aluminium foil and foil
containers
*) Combination of microwave with grill/convection or of grill with convec-
tion

operation of the device

A signal tone sounds when first turning the turning knob.
Your selection by pressing buttons is confirmed by a signal tone. If
not, you did not press properly.
If you set a program but do not press the START/+30SEC./CON-
FIRM button within 5 minutes, the setting will be canceled. The
display will then show the current time again.
When starting a program (except during pre-heating), the remaining
operating time will be displayed. The countdown runs.
5 signal tones will indicate the end of the program.
The casing is cooled by a cooling fan. The cooling fan may continue
to operate after a program is finished.

Initial operation

After removing all the accessories from inside the oven, unpack
them and place the sliding ring in the middle.
Position the glass plate on the drive axle in such a way that it locks
into the dents of the drive shafts and is lying flat.
Check the device for any visible damage, particularly in the area of
the door. If any damage is found, the machine must not be used.
In order to avoid interference to other machines when the micro-
wave oven is operated, do not place it in the direct vicinity of other
electronic devices.
Remove any protective foils that may be adhered to the housing.
Insert the mains plug into a properly installed 230 V ~, 50 Hz
power socket.
CAUTIoN:
Do not remove any installed parts from inside the oven or from inside
the door!
NoTE:
If there are any oil or other residues from the manufacturing process
on the housing or heating element, smoke or odours may initially be
produced.
This is normal and will not occur after the oven has been used a few
times.
The following procedure is strongly recommended:
Turn the device to the grill function and allow it to run several times
without any food inside.
Please ensure sufficient ventilation.
Suitable for
micro-
Convec-
grill
wave
tion
yes
yes
yes
no
no
no
yes
yes
yes
yes
no
no
yes
no
no
no
yes
yes
no
yes
yes
no
yes
yes
combi-
nation*
yes
no
yes
no
no
no
no
no

Werbung

Kapitel

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis