SEVERIN KS 9789 Gebrauchsanweisung Seite 17

If the refrigerator is installed with its side
against a wall, ensure a minimum clearance
of 60 mm to ensure that the door can open
through 90°.
To remove the fresh-storage compartment,
the bottle rack must be taken out first.
Reversible door
If required, the door may be reversed, i.e. from right-hinged (default installation) to left-hinged.
To avoid the risk of personal injury or damage to the unit, two people are needed to reverse the door.
Warning: Always disconnect the unit from the mains before any maintenance or repair work is
carried out.
Before you get started, please note the following:
 Always ensure that the correct number of washers is used on all hinge bolts and screws.
 So that the doors can close tightly against the frame, take the utmost care that they are properly
aligned during re-assembly.
– Open the refrigerator door.
– Remove the four covers C from the housing and inside of the door
– Replace the covers and their extensions, turned through 180°, on the opposite side.
– Unscrew the hinge bolt on the inside of the door in the area C/6.
Caution: Support the door.
The heated air around the rear of the unit
must be able to circulate freely. Therefore,
ensure that the air circulation behind the unit
is not obstructed.
Caution: Ensure at all times that the rear
ventilation openings around the top cover
are not obstructed.
17