Denon AVR-1905 Bedienungsanleitung Seite 12

ENGLISH
Before setting up the system
1
Refer to "CONNECTIONS" (pages 5 to 9) and check that all connections are correct.
2
Press the Power switch (button).
ON OFF
• ON
¢
The power turns on and indicator is light.
Set the power switch to this position to turn the power on and off from the
(Main unit)
included remote control unit.
• OFF
£
The power turns off and indicator is off.
In this position, the power cannot be turned on and off from the remote control
unit.
3
Turn on the power.
ON / STANDBY
Press the Power ON/STANDBY switch (button).
(Main unit) (Remote control unit)
4
Press the SYSTEM SETUP button to enter the
setting.
*SYSTEM SET UP
(Remote control unit)
NOTE: Please make sure the "AUDIO" position of
the slide switch on the remote control unit.
5
Press the ENTER or
Setup.
(Remote control unit)
NOTE:
• Press the SYSTEM SETUP button again to finish system set up. System set up can be finished at any time.
The changes to the settings made up to that point are entered.
12
(down) button to switch to the Speaker Configuration
Setting the type of speakers
• Set up in function of your speaker systems. Performing this setup optimizes the system.
• The composition of the signals output to the different channels and the frequency response are adjusted
automatically according to the combination of speakers actually being used.
1
Set whether or not speakers are connected and, if so, their size parameters.
• To select the speaker
(Remote control unit)
(Remote control unit)
• To select the parameter
1 FRONT
2
Press the ENTER or
SPEAKER DISTANCE setting.
(Remote control unit)
• Parameters
Large.................Select this when using speakers that have sufficient performance for reproducing bass sound
below the frequency set for the Crossover Frequency mode.
Small .................Select this when using speakers that do not have sufficient performance for reproducing bass
sound below the frequency set for the Crossover Frequency mode. When this is set, bass
sound with a frequency below the frequency set for the Crossover Frequency mode is sent
to the subwoofer.
None .................Select this when no speakers are installed.
Yes/No...............Select "Yes" when a subwoofer is installed, "No" when a subwoofer is not installed.
2spkrs/1spkr .....Set the number of speakers to be used for the surround back channel.
If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when
"Small" is set for the front, center and surround speakers.
Front Sp. Center Sp. Front Sp.
Subwoofer
Listening position
Surround Sp.
Surround Sp.
Surround back Sp.
LARGE
(down) button to enter the settings and switch to the