Electrical Connection - AEG SANTO K 7 10 03-6 i Gebrauchs- Und Einbauanweisung

Place the small square on the guide
again and fix it with the screws sup-
plied.
Should the lining up of the furniture
door be necessary, use the clearance
of slots.
At the end of operations, it is neces-
sary to check if the door of the fur-
niture closes properly.
Fix cover (Hd) on guide (Hb) until it
clips into place.

Electrical connection

Before initial start-up, refer to the appliance rating plate to ascertain if sup-
ply voltage and current values correspond with those of the mains at the
installation location.
e.g.:
(i.e. 220 to 240 volts alternating current, 50 Hertz)
The rating plate is inside the appliance on the left.
A correctly installed, earthed socket is required for the electrical supply. The
supply must have a fuse rating of at least 10 Amps.
If the socket is not accessible once the appliance is built in, the electrical
installation must include suitable means of isolating the appliance from the
mains (e.g. fuse, cut-out, current trip or similar with a minimum contact
separation of 3 mm).
Attention: The mains connection cable may only be replaced by a skilled
electrician. Please contact your dealer or our customer service department
for repairs.
30
AC 220 ... 240 V
220 ... 240 V~ 50 Hz
Hb
PR168
Hb
Hd
PR167/1
50 Hz or