Sharp SD-NX10H Bedienungsanleitung Seite 163

Notes:


Recording from a CD to a MiniDisc starts even if all the tracks on the CD cannot fit
in the MiniDisc. In that case, both the CD and MD stop when the MD becomes full.


When the CD reaches its end, recording to MD will stop simultaneously.


You can record from a CD you programmed.


Recording can be performed in repeat playback mode. The repeat playback can be
switched during recording.
To stop recording:
Press the CD or MD button.
The CD and MiniDisc will stop.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
About track numbers:
New track numbers will be created auto-
matically according to the original tracks
(Synchro mark function).


When you record from a CD to a Mini-
Disc, the track numbers recorded on the
MiniDisc may not match the track num-
bers on the CD.
CD
First track Third track
Second track
Track A Track B Track C
MiniDisc
First track Second track Third track
Track A Track B Track C
Notes for long recording mode:


Tracks recorded in 2 times long recording or 4 times long recording mode cannot be
played with units that do not support these modes.


On such a unit, "LP :" is displayed at the beginning of the track and no sound is
heard. (The operation and the display may vary depending on the unit.)
Note for high speed recording:
Due to the scratch, dirt, or the recorded condition, the sound may be cut in pieces or
the noise is heard from the MD recorded in high speed. If this occurs, record the MD
at the normal speed.
Caution for 4 times long recording (LP4):
Special compressing method allows the 4 times long recording to realize long-time
stereo recording. Therefore, some noise is recorded occasionally.
If sound quality is the main requirement, stereo recording or 2 times long recording is
recommended.
ENGLISH
E-36