Herunterladen Inhalt Inhalt Diese Seite drucken

BOMANN KS 2184 Bedienungsanleitung Seite 18

Vorschau ausblenden Andere Handbücher für KS 2184:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

• Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
For information on the climate class, please refer
to chapter "Technical Data" or to the rating label
located in the interior or on the rear side of the
appliance.
• Place the appliance on a steady and safe surface.
If the appliance is not horizontally leveled, adjust
the feet accordingly.
• Avoid the installation:
Avoid the installation:
Avoid the installation:
Avoid the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
Assembling the rubber supporting pad
Assembling the rubber supporting pad
Assembling the rubber supporting pad
Assembling the rubber supporting pad
The screw and rubber supporting pad were send in a
plastic bag, so you can install these accessories
according to the following procedure:
NOTE:
NOTE:
NOTE:
NOTE:
• There is no need to install these accessories un-
der normal usage.
• Only under extreme circumstances, when the
cabinet is empty, while load on door with total of
15 kg. This appliance may take risk of tipping.
• Tilt appliance to
find screw hole on
the left of lower
base cover.
• Put the screw into
the hole of rubber
supporting pad.
• Put screw with the
rubber supporting
pad in the hole.
Turn the screw
firmly by a cross
screw driver.
Electrical connection
Electrical connection
Electrical connection
Electrical connection
WARNING:
WARNING:
WARNING:
WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock!
shock
shock
shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
C C C C AUTION
AUTION
AUTION: : : :
AUTION
In case of disconnection or power failure:
Wait for approx. 5 minutes before restarting.
-
Check the operation settings.
-
• Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reverse the door opening
Reverse the door opening
Reverse the door opening
Reverse the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
WARNING:
WARNING:
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
18
electric
electric
electric

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis