Werbung
ance can be used as footed appliance. It can be also used as wall appliance by means of a wall bracket.
The appliance is to be used solely for heating rooms or moderating their temperature. The appliance is de-
signed for normal domestic use.
Technical specifications
Type
Nominal voltage
Power
Switch levels
Type of appliance
Protection class
Protection type
Approx. dimensions (W x H X D)
Approx. weight
Construction and operating parts (see illustrations on page 2)
Heat radiation grid
Pilot lamp
Rotary switch
Thermostat
Unpacking the appliance
- Check the appliance for visible damages. If you notice any damage do not use the appliance. Please con-
tact your dealer immediately.
- Do not forget to unpack the support feet. You will find them on the side of the packaging.
- Please dispose of the packaging in an environmentally-friendly manner.
Use the appliance as footed appliance
Mount both support feet beneath the underside of the appliance (see fig. 3 on page 2).
- Place the support feet on the 3 bolts below the appliance.
- Fasten the feet onto the convector with the 2 screws provided.
- Plug it in. ¬ The convector is now ready for operation.
Use the appliance as wall appliance (see figures 4, 5 on page 2)
Please observe strictly the safety instructions as stated on the last pages.
For wall-mounting, the support feet are used as wall mounting brackets.
- Mount the support feet on the wall with 4 pins Ø 6 x 30 mm and 4 screws Ø 5 x 30 mm. Please observe
the correct distances. The dimensions of the required holes are shown in figure 4. Make sure that no
other installations (e.g. electricity or water) are located in the immediate vicinity of the drill-holes.
- Push out the hooks on the support feet.
- Hang the appliance on the support feet as shown in fig. 4.
- Connect the plug to the mains socket. ¬ The convector is now ready for operation.
Rotary switch positions (see fig. 2)
0
- Heating is turned off
1
- Heating, 400 W
2
- Heating, 600W
MAX
- Heating, 1000W
While appliance is switched on, the pilot lamp lights up.
Thermostat function
The thermostat turns the appliance on and off automatically. If the room temperature remains below the
temperature set, the appliance will start to heat until the required temperature is reached again.
F
- lowest thermostat setting (frost protection position, approx. +5°C)
o o o
- continuous setting range
MAX
- highest thermostat setting
- see type label -
OFF / 400 W / 600W / 1000 W
Thermostat with frost protection function
Wall appliance / footed appliance
Footed appliance:
71 cm x 43 cm x 18.2 cm
Wall appliance:
71 cm x 41 cm x 17 cm
2 feet with 2 fixing screws
Power cable
Mains plug
Technical modifications reserved
WW 120 K
1000 W
I
IP 20
4.15 kg
5
Werbung
