Attachment To The Wall Via The Optional Wall Holder; Incorrect Methods Of Installation - Omnitronic Control 1 Bedienungsanleitung

When rigging, derigging or servicing the device staying in the area below the installation place, on lighting
bridges, under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
The device should be installed outside areas where persons may walk by or be seated.
IMPORTANT! Overhead rigging requires extensive experience, including (but not limited to) calculating load
capacity, installation material being used, and periodic safety inspection of all installation material and the
device. If you lack these qualifications, do not attempt the installation yourself, but instead use a professional
structural rigger. Improper installation can result in bodily injury and or damage to property.
Caution: Devices in hanging installations may cause severe injuries when crashing down! If you have
doubts concerning the safety of a possible installation, do NOT install the device!

4.2 Attachment to the wall via the optional wall holder

The device must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant
location. Make sure that the device is installed absolutely planar by using a water-level.
The device must be installed out of the reach of people.
This device is only allowed for an installation via the mounting bracket. In order to safeguard sufficient
ventilation, leave 50 cm of free space around the device.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
Procedure:
Step 1: Hold the wall holder onto the location where the speaker system is to be installed.
Step 3: On the holder are installation holes. Mark the boreholes with a pen or a suitable tool and drill the
holes.
Step 4: Fix the holder to the wall.
Step 5: Fix the speaker system to the holder and adjust the vertical and horizontal angle of inclination.

4.3 Incorrect methods of installation

This speaker system must never be stacked - Danger to Life due to crashing speaker systems!
This speaker system must never be suspended - Danger to Life due to crashing
speaker systems!
DANGER!
13/16 00053940.DOC, Version 3.1