Operation; Remote Control; Switching The Leds On And Off; Constant Lighting In One Color - EuroLite LED IP FL-30 Bedienungsanleitung

OPERATION

Remote control

The remote control is supplied with battery inserted.
A barrier foil between the battery and the battery contacts prevents the battery from being discharged during
storage. Prior to the first operation remove the foil from the battery support on the rear side of the remote
control. Otherwise operation of the remote control is not possible.
When actuating a button, always hold the remote control in the direction of the sensor. There must be visual
connection between the remote control and the sensor.
If the range of the remote control decreases (7 meters as a maximum), replace the
battery. For this purpose, on the rear side of the remote control press the small bar
with the groove to the right and at the same time remove the battery support.
For operation, one 3 V button cell type CR 2025 is required. When inserting, pay
attention that the positive pole of the button cell shows upwards in the support.
CAUTION!
Danger of explosion when battery is replaced improperly. Only replace by the same type. Please dispose of
old and used batteries properly. Batteries are hazardous waste and should not be disposed of with regular
domestic waste!

Switching the LEDs on and off

The LEDs can be switched on with the button ON and switched off with the button OFF.

Constant lighting in one color

For constant lighting of all LEDs in one color, press the corresponding color button. Use the buttons and
to adjust the brightness in 8 levels for the static colors.
14/16 00092228.DOC, Version 1.0