Operation; Daily Use; Cleaning The Interior; Temperature Indicator - Electrolux ERN2314AOW Benutzerhandbuch

obtain from your local authorities.
Avoid damaging the cooling unit,
especially at the rear near the heat

2. OPERATION

2.1 Switching on
Insert the plug into the wall socket.
Turn the Temperature regulator clockwise
to a medium setting.
2.2 Switching off
To turn off the appliance, turn the Tem-
perature regulator to the "O" position.
2.3 Temperature regulation
The temperature is automatically regula-
ted.
To operate the appliance, proceed as fol-
lows:
• turn the Temperature regulator toward
lower settings to obtain the minimum
coldness.
• turn the Temperature regulator toward
higher settings to obtain the maximum
coldness.

3. DAILY USE

3.1 Cleaning the interior

Before using the appliance for the first
time, wash the interior and all internal ac-
cessories with lukewarm water and some
neutral soap so as to remove the typical

3.2 Temperature Indicator

exchanger. The materials used on
this appliance marked by the sym-
bol are recyclable.
A medium setting is generally the
most suitable.
However, the exact setting should be
chosen keeping in mind that the tempera-
ture inside the appliance depends on:
• room temperature
• how often the door is opened
• the quantity of food stored
• the location of the appliance.
If the ambient temperature is high
or the appliance is fully loaded,
and the appliance is set to the
lowest temperatures, it may run
continuously causing frost to form
on the rear wall. In this case the
dial must be set to a higher tem-
perature to allow automatic de-
frosting and therefore reduced en-
ergy consumption.
smell of a brand-new product, then dry
thoroughly.
Do not use detergents or abrasive
powders, as these will damage
the finish.
This appliance is sold in France.
In accordance with regulations
valid in this country it must be
provided with a special device
(see figure) placed in the lower
compartment of the fridge to indi-
cate the coldest zone of it.
ENGLISH 17