Dimplex VFR 20 Montage- Und Gebrauchsanweisung Seite 23

Fig. 10: Remove the core space cover. To do this, unscrew
the middle fixing screw. Lift the core space cover slightly and
swing it outwards (A). Then pull the core space cover to the
right (B). Put the core space cover down carefully to ensure
that the thermal insulation is not damaged.
.
Fig. 11: Remove the protective packaging (corrugated card-
board).
www.dimplex.de
Fig. 12: Attach the stabiliser.
ATTENTION!
The equipment must be secured to ensure it doesn't tilt.
Once assembled, the upper edge of the storage heater
must be able to withstand a horizontal strain of at least
200N, without tilting or shifting. If the required stability
cannot be achieved with the supplied accessories, for
example, if the wall is not solid enough, the installer
must use a more suitable method of attaching the heater
to the wall.
Fig. 13: Place the lowest layer of core bricks into the core
space, starting from the right.
459562.66.01 · 03/15/C
VFR 20 - VFR 70
EN-23