Trouble Shooting Guide - Silvercrest IAN 114195 Bedienungs- Und Sicherheitshinweise

Trouble shooting guide

Problem Cause
Upper thread 1.The machine is not threaded correctly.
breaks 2.The thread tension is too tight.
3.The thread is too thick for the needle.
4.The needle is not inserted correctly.
5.The thread has become wound
around the bobbin winder spindle (14).
6.The needle is damaged.
Lower thread 1.The bobbin case is not inserted
breaks correctly.
2.The bobbin case is threaded wrongly.
Skipped stitches 1.The needle is not inserted correctly.
2.The needle is damaged.
3.The wrong size needle has been
used.
4.The wrong presser foot is installed.
Needle breaks 1.The needle is damaged.
2.The needle is not correctly inserted.
3.Fabric too thick/ needle size wrong.
4.The wrong presser foot is attached.
Loose stitches 1.The machine is not correctly threaded.
2.The bobbin case is not correctly
threaded.
3.Needle/ fabric/ thread combination is
wrong.
4.Thread tension wrong.
Seams gather 1.The needle is too thick for the fabric.
or pucker 2.The stitch length is wrongly adjusted.
Uneven stitches, 1.The thread is too weak.
uneven feed 2.The bobbin case is wrongly threaded
3.Fabric has been pulled when sewing.
The machine is 1.The machine must be lubricated.
noisy 2.Fluff or oil have collected on the hook
or needle bar.
3.Poor quality oil has been used.
4.The needle is damaged.
Thread wraps The second thread spool pin was not
around thread used.
spool pin
The machine Thread is caught in the hook.
jams
Correction
1.Rethread the machine.
2. Reduce the thread tension (3). (lower number)
3.Use a larger needle.
4.Remove and reinsert the needle. (flat side
towards the back)
5.Remove the bobbin (g) and unwind the
thread.
6.Replace the needle.
1.Remove and reinsert the bobbin case and
pull on the thread. The thread should pull
easily.
2.Check both bobbin (g) and bobbin case.
1.Remove and reinsert needle. (flat side
towards the back)
2.Replace the needle.
3.Choose a needle size to suit the thread and
fabric.
4.Use the correct presser foot.
1.Replace the needle.
2.Insert the needle correctly (flat side towards
the back)
3.Choose a needle size to suit the thread and
fabric.
4.Use the correct presser foot.
1.Thread the machine correctly.
2.Thread the bobbin case as illustrated.
3.The needle size must suit the fabric and
thread.
4.Correct the thread tension.
1.Use a finer needle.
2.Check the thread tension.
1.Use stronger thread.
2. Rethread the bobbin case and insert correctly.
3.Do not pull on the fabric. It must be
automatically moved by the machine.
1.Lubricate as described.
2.Clean the hook and feed dog as described.
3.Only use good quality sewing machine oil.
4.Replace the needle.
Proceed according to the directions on page
77, "Setting up the thread spool pins".
Remove the upper thread and bobbin case,
turn the handwheel (21) backwards and
forwards by hand and remove the thread
remains. Lubricate as described.
Maintenance
GB / IE 91