Blind Stitch Foot; Button Sewing Foot - Silvercrest IAN 114195 Bedienungs- Und Sicherheitshinweise

Sewing basics

Blind stitch foot

1
2

Button sewing foot

84 GB / IE
Stitch
D
For hems, curtains, trousers, skirts, etc.
4
Blind stitch for elastic fabrics.
1. Fold the fabric as illustrated with the
left side uppermost.
2. Place the reversed fabric under the
3
presser foot. Turn the handwheel (21)
forwards by hand until the needle is
fully to the left. It should just pierce the
fold of the fabric. If it does not, adjust
the stitch width accordingly.
3/4.Adjust the guide (3) by turning the dial
(4) so that the guide just rests against
the fold.
Sew slowly and guide the fabric carefully
so that its position does not change in
relation to the guide.
Stitch
B
Install the embroidery and darning plate
(o).
Position the work under the foot. Place
the button on the marked position, lower
the presser foot, adjust stitch width to "0"
and first sew a few securing stitches in
the left hole. Adjust the stitch width
(usually between 3 and 4). Sew some
check stitches with the handwheel (21)
until the needle goes cleanly into the right
hole of the button (vary the stitch width
depending on the button) and sew on the
button. Adjust the stitch width to "0" and
sew a few securing stitches.
If a shank is required, place a darning
needle on top of the button and sew. For
buttons with 4 holes, sew through the
front two holes first, push the work
forward and then sew through the back
two holes as described.
Stitch width Stitch length
1~2 3~4
Stitch width Stitch length
0~5 0