VEGA VEGAFLEX 83 Betriebsanleitung Seite 89

FF desciptor
DIAG_MASK_2
DIAG_OUT_2
DEVICE_IDENTIFICATION
DEVICE_NAME
IS-SPARE_ELECTRONICS
DEVICE_VERSION_INFO
CALIBRATION_DATE
FIRMWARE_VERSION_ASCII Software version
HW_VERSION_ASCII
ADJUSTMENT_DATA
FIRMWARE_VERSION_MAIN Firmware versions major, minor, revision and build
PHYSICAL_VALUES
DEVICE_UNITS
APPLICATION_CONFIG
LINEARIZATION_TYPE_SEL
SIMULATION_PHYSCAL
INTEGRATION_DATA
DEVICE_CONFIG_PULS_
RADAR
ADJUSTMENT_LIMITS_MIN
ADJUSTMENT_LIMITS_MAX
FALSE_SIGNAL_COMMAND
FALSE_SIGNAL_CMD_
CREATE_EXTEND
FALSE_SIGNAL_CMD_DE-
LET_REGION
FALSE_SIGNAL_CMD_STATE Busy, last command, errorcode
FALSE_SIGNAL_CMD_CON-
FIGURATION1
FALSE_SIGNAL_CMD_CON-
FIGURATION2
ECP_CURVE_AVARAGING_
CONFIG
LEVEL_ECHO_MEASURE-
MENT
ECHO_CURVE_STATUS
PACKET_COUNT
VEGAFLEX 83 • Foundation Fieldbus
Description
Manufacturer ID, device type, bus type ID, measurement prin-
ciple, serial number, DTM ID, device revision
Device name
Device name
Hard- and software version for system, function and error
Day, month and year
Hardware version
Min./max.-adjustment physical, percent and offset
Distance, distance unit, distance status, level and status
Distance and temperature units of the instrument
Medium type, media, application type, vessel bottom, vessel
height
Type of linearization
Physical offset and integration time
Electronics variant, probe type, max. measuring range, anten-
na extension length, adjustment propagation antenna extension
lprapproval configuration
Min. range min.-/max.- values physical, percent, offset
Max. range min.-/max.- values physical, percent, offset
Amplitude safety of the 0 % curve, safety of the false signal sup-
pression, position of the 0 % and 100 % curve in near and far
range
Gradient of the manual sectors, safety at the end of false echo
memory and depending on the import range gating out the fal-
se signals
Averaging factor on increasing and decreasing amplitude
Function measured value filter
11 Anhang
Unit
%
%
89