Replacing The Lamp; Closing The Door; Installation - Electrolux ERG3093AOW Benutzerhandbuch

Problem
Temperature cannot
be set .
The temperature in
the appliance is too
low/high.
The temperature in
the refrigerator is
too high.
Upper or lower
square is shown in
the temperature dis-
play.
DEMO appears on
the Display.

6.1 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your Service Cen-
ter .

6.2 Closing the door

1.
Clean the door gaskets.

7. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
Possible cause
Shopping function switch-
ed on.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
An error has occurred in
measuring the tempera-
ture.
The appliance is in dem-
onstration mode (DEMO).
2.
3.
the climate class indicated on the rating
plate of the appliance:
Solution
Switch off Shopping man-
ually, or wait to set the tem-
perature until the function
has reset automatically. Re-
fer to ShoppingMode .
Store less products at the
same time.
Make sure that there is cold
air circulation in the appli-
ance.
Call your service represen-
tative (the cooling system
will continue to keep food
products cold, but temper-
ature adjustment will not be
possible).
Keep pressed approximate-
ly 10 sec. the Mode button
since a long sound of buz-
zer is heard and the Display
shut off for a short while:
appliance start works regu-
larly.
If necessary, adjust the door. Refer to
"Installation".
If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH 15