WolfVision VZ-C12 Bedienungsanleitung Seite 8

The Visualizer can be readjusted if necessary.
By loosening the hex safety screws the unit can be turned by 45 degrees to the left or right (please
make sure that the hex safety screws are retightened after readjustment). The unit can also be moved
backwards or forwards +/- 30mm (1.18") by loosening the mounting plate screws (please make sure
that the mounting plate screws are retightened again after readjustment).
Also, the Visualizer can be moved to the right or left by loosening the 4 lock bolts (again, please make
sure that these bolts are retightened afterwards).
INSTALLATION OF AN EXTERNAL CEILING MOUNT
If the Visualizer needs to be suspended further from the ceiling than with the supplied ceiling mount
(in order to allow greater magnification), a standard ceiling mount or ceiling lift for projectors may be
used. An adapter plate, suitable for weight and screw fittings for the Visualizer, might be necessary.
Fixing the assembly to the ceiling depends on the particular construction and circumstances of the
desired mounting location.
(176 pounds) and that possible collision accidents are prevented.
Important: Please give special attention to the country specific regulations for
training and conferencing rooms!
IMPORTANT: Ensure solid mounting and secure connection of all parts to
avoid the possibility that the unit detaches itself from the ceiling.
+/- 45°
+/- 30 mm
Ensure that the ceiling construction is able to carry a weight of 80 kilos
+/- 30 mm
6