Reset To Factory Default Settings - MADRIX PLEXUS Kurzanleitung

Reset To Factory Default Settings

In rare cases, you might want to restore the default settings of the device.
Follow these steps to carry out a device reset to factory default settings:
Step 1) Disconnect the device from USB/Power. It needs to be turned off.
Step 2) Depending on the display rotation of the device, press and hold
'OK' and DOWN at the same time. Continue to hold the two buttons.
Step 3) While pressing the two buttons, connect USB/Power again.
Step 4) Depending on the display rotation of the device, press UP to perform
the reset.
How To Open The Metal Lid
MADRIX PLEXUS is equipped with a metal lid at the top. It covers the SD card
®
slot, the extension port, and the Kensington Security Slot.
Opening The Lid
Step 1) Hold the PLEXUS at the left and right side with both hands.
You should face the display. Place your thumbs near the display.
Step 2) Use both index fingers at the back of the device to push the lid
towards you. Push at the upper edge of the device.
Step 3) Use your thumbs to push the lid upwards.
Closing The Lid
It is recommended to close the metal lid whenever possible during use and
storage. To close the lid again, push it down to its original position. You may
hear a clicking sound.
6