Web Configuration; Reset To Factory Default Settings - MADRIX LUNA Kurzanleitung

IP Address And Other Device Information
You will find the following important information on the back side of the device:
- Serial number ('Serial')
- Hardware revision ('Model')
- Default and preconfigured IP address ('Default IP')

Web Configuration

You can access various settings and information of MADRIX
configuration interface, in case that the device is connected to a network.
Step 1) Connect MADRIX
Step 2) Open your web browser and enter the IP address of MADRIX
(As described above, you can find the default IP address on the back
side of the device.)
Step 3) The web configuration interface will be launched.
You will have access to different settings, such as the IP address.

Reset To Factory Default Settings

In rare cases you might need to restore the default settings of the device.
Follow these steps to carry out a reset to factory default settings:
Step 1) Disconnect the device from power.
Step 2) Use a suitable tool to press the reset button on the unit's back side.
Step 3) Continue to press the reset button and connect to power again.
Step 4) Continue to press the reset button and wait until all status LEDs
on the front of the device flash repeatedly or wait 10 seconds.
Note: Simply repeat these steps should the process fail.
Using Any 3rd-Party Controller Via Art-Net
MADRIX LUNA is a standard Art-Net node. Because of this, you can use the
®
device with any application, console, or controller that supports Art-Net to
distribute Art-Net data via Ethernet network.
7
LUNA and your computer to the same network.
®
LUNA using a web
®
LUNA.
®