Setting And Starting Aprogramme - Electrolux WAGL6S200 Benutzerhandbuch

Check the position of the flap
1. Pull out the detergent dispenser until it
stops.
2. Press the lever down to remove the
dispenser.
3. To use powder detergent, turn the flap
up.
4. To use liquid detergent, turn the flap
down.
5. Measure out the detergent and the fab-
ric conditioner.
6. Carefully close the detergent dispenser.
Make sure that the flap does not cause
a blockage when you close the drawer.
With the flap in the position DOWN:
– Do not use gelatinous or thick liquid
detergents.
– Do not put more liquid detergent
than the limit showed in the flap.
– Do not set the prewash phase.
– Do not set the delay start function.
SETTING AND STARTING A
PROGRAMME
1. Turn the programme knob. The related
programme indicator comes on.
2. The indicator of button
red colour.
3. The display shows the default tempera-
ture and spin speed. To change the
temperature and/or the spin speed,
press the related buttons.
4. Set the available functions. The indica-
tor of the set function comes on or the
display shows the related symbol.
5. Press button
4
gramme. The indicator of button
on.
The drain pump can operate for a short
time when the appliance fills water.
The appliance adjust automatically the cy-
cle time to the laundry you have put in the
drum to have perfect washing results in
the minimum necessary time. After ap-
proximately 15 minutes from the start of
the programme, the display shows the
new time value.
INTERRUPT A PROGRAMME
1. Press button
4
2. Press button
4
programme continues.
CANCEL A PROGRAMME
1. Press button
1
gramme and to deactivate the appli-
ance.
2. Press button
1
appliance. Now, you can set a new
washing programme.
The appliance does not drain the wa-
ter.
CHANGE A FUNCTION
You can change only some functions be-
fore they operate.
1. Press button
4
electrolux 13
4 flashes with
to start the pro-
4
. The indicator flashes.
again. The washing
to cancel the pro-
again to activate the
. The indicator flashes.
is