Master/Slave Operation; Dmx-Controlled Operation; Addressing - EuroLite LED SCY-3 Bedienungsanleitung

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master-
device.
On the side panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a DMX cable. Connect the DMX
OUT-jack with the DMX IN-plug of the next device.
Set the desired Master-mode for the master-device. Set the respective Slave-mode for all slave-devices.
Please refer to the instructions under Control Board.

DMX-controlled operation

You can control the device individually via your DMX-controller. Every DMX-channel has a different
occupation with different features. The individual channels and their features are listed under DMX-protocol.
The device has four DMX channel modes. The Control Board allows you, as described above, to assign the
DMX channel mode.

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED SCY-3 Beam Effect will respond to the controller.
If you set, for example, the address in the 12 channel mode to channel 13, the LED SCY-3 Beam Effect will
use the channel 13 to 24 for control.
Please, be sure that you don't have any overlapping channels in order to control each LED SCY-3 Beam
Effect correctly and independently from any other fixture on the DMX-chain.
If several LED SCY-3 Beam Effects are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the device
via your lighting controller.
Note:
The modes of DMX512 data are shown via the display of the device:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the display will show "d.001" with the actually set address. If there is no data received at the
DMX-input, the display will show "d001" with the actually set address.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
31/35 00088051.DOC, Version 1.0