Setup; Setup Location Requirements - Caso WineDuett 12 Bedienungsanleitung

13.5 Setup

13.5.1

Setup location requirements:

caso Wine Duett
In order to ensure the safe and trouble-free operation of the
device, the setup location must fulfil the following prerequisites:
• Place your appliance on a floor that is strong enough to support
the appliance when it is fully loaded.
• Locate the appliance away from direct sunlight and sources of
heat (stove, heater, radiator, etc.). Direct sunlight may affect the
acrylic coating and heat sources may increase electrical
consumption.
• Ambient temperature below 16°C or above 32°C will hinder the
performance of the appliance.
• This unit is not designed for use in a garage or any other
outside installation.
• Do not set up the device in a hot, wet or extremely damp
environment or near flammable material.
• The device requires an adequate flow of air in order to operate
correctly. Leave a clearance of 10-15 cm around the appliance.
• Do not cover up any openings on the device and do not block
these off.
• The electrical socket must be easily accessible so that the
power lead can be disconnected easily, in the case of an
emergency.
• The installation and assembly of this device in non-stationary
setup locations (e.g. on ships) must be carried out by specialist
companies / electricians, provided they guarantee the
prerequisites for the safe use of this device.
• For energy saving reasons please ensure that the door is
closed when the appliance is turned on.
Commissioning
35