Matrix DWS 1200 Betriebsanleitung Seite 27

positions (A, B).
Tool side Suitable for
Left (position A) Right-handed users
Right (position B) Left-handed users
6. Operation instruction
1) Main switch and speed adjuster (B2,B3)
This machine is equipped with a lock-on switch
which can keep the machine on the "on" position.
a. To switch the machine's motor "On": Press
the main switch(item 7) to start the power tool.
b. To maintain the machine "on": Press the lock-
on button(item2) to maintain it on.
c. To switch the machine's motor "off ": slightly
press the main switch and release it to switch off
the machine.
d. The Motor Speed Control: Rotate the thumb
wheel until the required speed is obtained. Press
the main switch slightly to release the main
switch.
2) Sandpaper installing and replacement. (B4)
Note: Prior to installation or removing
the sandpaper, make sure to not only
switch off the device, but also cut off the power
supply.
• Installation Guide
To ensure the replacement procedures, place
the device on the smooth ground prior to
installation. Take the sandpaper from the toolbox,
and then fix it onto the disk (see Fig .2). The back
of the sandpaper (Item 9) will automatically glue
with the disk/adhesive disk (Item 10), making
both connection and conduction available.
In order to promote the sanding and polishing
efficiency, it is necessary to change the
sandpaper after the device has been operational
for a certain period. Firstly, switch off the device
and disconnect the socket. Then, remove the
previous sandpaper entirely from the disk, so as
to lay new sandpaper neatly as well as facilitate
future replacement. At last, fix new sandpaper in
position.
• Sandpaper Overview
Sanding and polishing towards the target wall
and object is possible with abrasive grains
and sandpaper twisting upon operations. The
sandpaper is classified into various categories
according to its dimensions. It is recommended
to select the sandpaper in accordance with
actual size of the disk. The more abrasive grains
included on the sandpaper, the better flatness
and parallelism can be achieved via sanding
and polishing, while the sanding and polishing
efficiency will fall accordingly and vice verse.
Therefore, the sandpaper is recommended upon
actual needs.
3) Sanding pad replacement (B5)
a. Remove the sandpaper;
b. Put the wrench into the hexagon hole in the
center of the viscid disc and then rotate the
wrench clockwise to take off the damaged viscid
disc;
c. Install the new viscid disc, rotate the viscid disc
clockwise.
4) Connection set for dust outlet
The dust outlet connector is used to connect the
machine with the cloth bag, making it possible to
reduce influence of dust to the operator t.
a. Connect the machine with the dust hose. (B6)
Installation Guide: Insert the dust hose into the
dust outlet, rotate the hose to the right to lock
the component with component A.
Dismantling Process: Rotate the lock to the left
and pull out the dust hose.
b. Connect the dust hose with the cloth bag.
27