Sharp XE-A213 Bedienungsanleitung Seite 59

2. Text programming (Press
:
(1) Press key to enter text programming.
Immediately after displaying guidance message, the
current text data will be displayed.
(2) Enter the text.
A maximum of 16 characters can be entered.
Please refer to "Guidance for text programming" on
page 14 for entering the text.
When you start entering a character, the current
text data will be overwritten by new data.
P
Pressing the
the right and left respectively.
s
(3) Press the key to register the text.
Immediately after displaying guidance message for
the next step, the current setting for the next step
will be displayed.
3. Rate programming (Press
(1) Enter the rate using numeric keys, using a decimal
point when setting fractional rates.
The rate can be set from 0.000000 to 999.999999.
Default setting is 0.000000.
s
(2) Press the key to register the rate.
Immediately after displaying guidance message for
the next step, the current setting for the next step
will be displayed.
4. Open rate entry programming (Press
(1) Go to (2) when the open rate entry does not need to
be changed from "OPEN ENABLE". Otherwise,
:
press key to display "OPEN DISABLE".
:
Each time key is pressed, the display shows
"OPEN DISABLE" and "OPEN ENABLE" alternatively.
Default setting is "ENABLE".
s
(2) Press the key to register the setting.
Immediately after displaying guidance message for
the next step, the current setting for the next step
will be displayed.
5. Preset rate entry programming (Press
(1) Go to (2) when the preset rate entry does not need to
be changed from "PRESET ENABLE". Otherwise,
:
press key to display "PRESEST DISABLE".
:
Each time key is pressed, the display shows
"PRESET DISABLE" and "PRESET ENABLE"
alternatively.
Default setting is "ENABLE".
s
to skip)
@
and key moves the cursor to
s
to skip. / Press
s
1 2
Part Part
A
to terminate.)
A
to skip. / Press
s A
to skip. / Press
3
FOR THE MANAGER
Part
:
ENTER TEXT
EXCH1
EX
EX
s
ENTER EX RATE
0.939938
s
OPEN RATE ENTRY
to terminate.)
s
PRESET RATE
PRESET ENABLE
to terminate.)
0.000000
0.939938
OPEN ENABLE
57