Using Multiple Satellites Via Diseqc 1.0 And Tone Burst; Using Multiple Satellites Via Diseqc 1; Using Multiple Satellites Via Diseqc 1.1 - Xoro HRS 8520 Bedienungsanleitung

Channel Search
4.

Using multiple satellites via DiSEqC 1.0 and Tone burst

The combination of DiSEqC1.0/1.1 and Tone burst allows you to choose up to eight satellites. That
means that to every LNB are two satellites defined.
1. Choose a satellite and define "Burst A" for
Tone burst and "LNB1 for DiSEqC1.0.
2. Choose a second satellite and confirm with
the OK button.
3. Change to the right side and define "Burst
A" for Tone burst.
4. Move by using the arrow button DOWN to
DiSEqC1.0 and choose the option LNB2.
5. And so on
You have the possibility to choose up to eight satellites. Press BLUE to start searching. A new menu
appears asking for more parameters. After setting all parameters press OK for starting the search.
The received programs are shown in the according lists and are saved when the search is finished.
5.

Using multiple satellites via DiSEqC 1.1

The distribution of analogue and digital signals from the Astra and Eutelsat is using DiSEqC™ (Digital
Satellite Equipment Control) is possible if only one cable to be laid to the satellite receiver. This new
tax system complements the conventional switching criteria, 14/18 Volt or 22 kHz, and removes the
restrictions on maximum 4 switching states. In the simplest version of DiSEqC™ is used between two
universal LNB switch to. The 22 kHz switching circuit is used for the lower and upper frequency band
LNB.
DiSEqC 1.0 controls up to four LNB with the command position A / B and Option A / B. DiSEqC 1.1
controls up to 64 LNB, it will switch in several levels of government. For 16 LNB, take for example
four 4 / 1 DiSEqC 1.0 switch, whose outputs are then placed on the inputs of a 4 / 1 DiSEqC 1.1
switch.
1. Choose a satellite and define in the menu
on the right "LNB1" for DiSEqC1.1
2. Press EXIT to change to the left side.
3. Choose a second satellite and confirm with
the OK button.
4. Change to the right side and define the
setting DiSEqC1.1 with the option LNB2.
5. And so on...
You have the possibility to choose up to 16 satellites. Press BLUE to start searching. A new menu
appears asking for more parameters. After setting all parameters press OK for starting the search.
The received programs are shown in the according lists and are saved when the search is finished.
22
First steps
HRS 8520