Commissioning; Preparing The Comfortel Ws-R2/R4 For Configuration - Auerswald COMfortel WS-R2 Inbetriebnahmeanleitung

Commissioning

This section describes the commissioning of the device. This
includes the preparation of the device, the initial configuration
and the connection.
Commissioning Overview

Preparing the COMfortel WS-R2/R4 for configuration

1.
(page 24)
Configuring the COMfortel WS-R2/R4
2.
Configuring the COM port
Setting up as mutli cell system
Connecting the COMfortel WS-R2/R4
3.
Preparing the COMfortel WS-R2/R4 for Con-
figuration
Requirements
– A repeater programming kit with the following components
Splitter
Adapter cable USB/RS-232 (COM port)
– A PC with installed ServiceTool programming software and
Internet connection for the driver installation
– A wall wart of type number 15.2189
– power socket
Warning: Inappropriate use or incorrect replacement of the
power plug can result in a life-threatening electric shock, or can
damage or destroy the device.
Only use the wall wart supplied with the equipment.
Important: You cannot configure the COMfortel WS-R2/R4
unless you perform the steps in the correct order.
The following steps must be performed in exactly this order:
Insert the splitter plug into the RJ-10 socket on the bottom
1.
side of the repeater.
Insert the wall wart plug into the RJ-10 socket on the splitter.
2.
Insert the wall wart plug into a power socket.
3.
Insert the adapter cable's USB connector into a USB socket
4.
on your PC.
24
Commissioning
COMfortel WS-R2/WS-R4 - Setup Guide V04 11/2015
(page 26)
(page 26)
(page 28)