F) Station Search/Preset; G) Saving A Station - Renkforce SR-2000U Bedienungsanleitung

f) Station Search/Preset

• First select the FM or AM tuner by pushing the button „TUNER/BAND" (K) on the receiver several
times.
The display shows „FM" or „AM", to display the respective frequency range to you (FM-tuner = FM
frequency range, AM-tuner = AM-frequency range).
To select with the IR remote control, first push the button „TUNER" (16) and then push the button
„BAND" (17) several times.
• Push the button „MODE/STORE" (D) on the receiver to switch between 3 operating modes (this is briefly
displayed each):
„AUTO": Automatic station search run
„MANUAL": Manual station search
„PRESET": Select station memory
• Depending on the chosen operating mode, you can now use the buttons „TUNING -/+" (E) to automati-
cally or manually find a station or select a station memory.
Operating mode „AUTO": Briefly push one of the buttons „TUNING -/+" (E) to start the automatic station
search. If a sufficiently strong station is recognised, search will stop automatically.
Operating mode „MANUAL": Briefly push one of the buttons „TUNING -/+" (E) to change the displayed
frequency step by step. Keep the respective button pressed for quick adjustment.
Operating mode „PRESET": Briefly push one of the buttons „TUNING -/+" (E) to select one of the station
memories. The respective number of the station memory is displayed. The station memories can be
programmed by you as described in chapter 13. g).

g) Saving a Station

Both for the FM and AM tuner, there are 15 memory slots each for your favourite stations. They can be
assigned as follows:
1. Select the desired frequency area (FM or AM).
2. Use the button „MODE/STORE" (D) to switch to the operating mode „AUTO" or „MANUAL" and find the
desired station, see chapter 13. f).
3. Briefly push the button „MEMORY" (21) on the IR remote control.
4. Now the next station memory is offered to you automatically (number in the left of the display); use the
buttons „TUNING -/+" on the receiver or IR remote control to select another if desired.
5. Briefly push the button „MEMORY" (21) on the IR remote control again to save the station.
50