Danger To Life - EuroLite Truss adapter Bedienungsanleitung

INSTALLATION
Please consider the
installation! The installation must only be carried out by an authorized dealer!
When rigging, derigging or servicing the fixture staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert before taking into operation for the first time and after changes before taking into operation another
time.
The operator has to make sure that safety-relating and machine-technical installations are approved by an
expert after every four year in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are approved by a
skilled person once a year.
Procedure:
IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not limited to)
calculating working load limits, installation material being used, and periodic safety inspection of all
installation material and the loads. If you lack these qualifications, do not attempt the installation yourself, but
instead use a professional structural rigger. Improper installation can result in bodily injury and.or damage to
property.
The stand has to be installed out of the reach of people.
Procedure
Loosen the fixation screw of the adapter. Install the adapter on the stand and tighten the fixation screw.
Arrange the couplers in the desired position tighten the fixation screws.
Install the crossbeam in the couplers and tighten the fixation screws.
Caution: The carrying capacity of the stand must never be exceeded!
Always fix the crossbeam with both couplers!
Carefully crank the stand to the desired height
Important!!
The maximum extension height and carrying capacity of the stand
Please note: The adapter may only be installed in the respective operating position and the load must be
one of pressure.
TAH = horizontal operating position
TAV = vertical operating position
The adapter load must never be one of traction.
Before taking into operation for the first time, the installation has to be approved by an expert!

DANGER TO LIFE!

DIN 15560-27 and the respective national norms during the
should never be exceeded
DANGER TO LIFE!
6/7
.
00040258.DOC, Version 2.2