Emptying The Permanent Filter And Collection Vessel; Cleaning; Collection Vessel; Accessories - Clatronic BSS 1309 Bedienungsanleitung

You may remove the shampoo device completely. Proceed
as follows:
1. Open the clamps at the suction hose.
2. Pull off the spray device towards the suction hose.
WARNING:
Take care of your fingers! The spray device must be
pulled off with a lot of force.

Emptying the Permanent Filter and Collection Vessel

1. Set the On / Off switch to O. Pull the plug out of the
socket.
2. Open the locking mechanisms. Remove the motor

housing.

WARNING:
• Before cleaning remove the mains lead from the socket.
• Under no circumstances should you immerse the motor housing
in water in order to clean it. Otherwise this might result in an elec-
tric shock or fire.
CAUTION:
• Do not use a wire brush or any abrasive items.
• Do not use any acidic or abrasive detergents.

Collection Vessel

• Rinse out the collection vessel after use with clean water.
• Any dirt in the vessel can be removed with a sponge or
nylon brush.
• Hold your appliance over a correspondingly large vessel
and counterclockwise twist off the lid.

Accessories

All parts may be cleaned under warm running water.
NOTE:
• For cleaning purposes you may remove the bristles of
the shampoo brush. For this pull them off to the side.
• Restart operation only with dried accessory.
46
BSS1309
3. Pull off the permanent filter if necessary. Shake it out.
4. Remove the suction hose.
5. Empty the collection vessel.
NOTE:
There is an outlet opening underneath the suction port.
Hold your appliance over a correspondingly large vessel
and counterclockwise twist off the lid.
6. If necessary, put the permanent filter over the protective
filter again.
7. Reassemble the hose connection and the motor housing.
8. Close the locking mechanisms.
9. You can now use the vacuum cleaner again.

Cleaning

Housing
The housing can be wiped off with a slightly damp cloth.
• Clean the appliance as described and allow it to dry.
• There are 4 plug-in connections at the engine housing
and on the appliance feet in total. There you may stow the
nozzle attachments.
NOTE:
These are not suitable for the suction pipes.
• We recommend that you keep the appliance in the origi-
nal packaging if it will not be used for long periods.
• Always store the appliance out of the reach of children in
a dry, well ventilated place.

Storage

16.10.17