Electrolux LAVATHERM T37850 Benutzerhandbuch Seite 45

Loading door does not close.
When a button is pressed,
appears on the LCD.
Drum light does not work.
Displayed programme time
changes erratically or stays un-
changed for a long time.
Drying cycle ends shortly after
programme starts.
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends au-
tomatically.
Changing the bulb for interior lighting
Only use a special bulb which is designed specially for dryers. The special bulb can be
obtained from your local service centre.
When the appliance is switched on, the interior lighting switches itself off after 4 minutes
when the door is open.
WARNING!
Do not use standard bulbs! These develop too much heat and may damage the machine!
Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully
unscrew or deactivate the fuse.
1. Unscrew cover above the bulb (this can be found directly behind the loading aperture,
at the top; refer to "Description of machine" section.)
2. Replace defective bulb.
3. Screw cover back down.
Conductance of water at in-
stallation site differs from
standard setting of machine.
Filter not in place.
Washing protection. After the
Err
start of the programme, the
option can no longer be set.
Programme selector in UIT (off)
position.
Defective light bulb.
Programme time is corrected
automatically depending on
type and volume of laundry
and level of dampness.
Not enough washing loaded or
washing loaded is too dry for
selected programme.
Filter clogged.
Load volume too big.
Laundry insufficiently spun.
Particularly high room temper-
ature. Temporary switching off
of the compressor to avoid
overload.
What to do if ...
Re-programme standard set-
ting for degree of drying (see
'Programming options' chap-
ter).
Install filter into place.
Turn the programme knob to
UIT (off). Set the programme
again.
Turn programme selector to
LICHT AAN (light) or to any pro-
gramme.
Replace light bulb (see next
section).
Automatic process; this is not a
machine fault.
Select time programme or
higher drying level (e.g. EXTRA
DROOG (extra dry) instead of
KASTDROOG (stroage dry)).
Clean filter.
Reduce load volume.
Laundry must be adequately
spun.
Automatic process, there is no
fault with the appliance. If pos-
sible, lower the room tempera-
ture.
45