Electrolux WASL3T100 Benutzerhandbuch Seite 43

Problems
Wash is unsatisfactory :
The appliance vibrates, is
noisy :
the wash cycle is much too
long :
The washing machine
stops during a wash cycle :
The lid doesn't open at the
end of the cycle :
The E40 error code ap-
**
pears in the display
the Start/Pause pushbut-
***
ton flashes red :
Causes
• the detergent is unsuitable for machine
washing,
• there is too much washing in the drum,
• the wash cycle is unsuitable,
• there isn't enough detergent.
• the appliance hasn't been untied properly (see
untying section),
• the appliance isn't level and is unbalanced,
• the appliance is too close to the wall or furni-
ture,
• washing is unevenly distributed in the drum,
• the load is too small.
• the water inlet filters are dirty,
• the power or water supply has been cut off,
• the motor overheating detector has been acti-
vated,
• the water inlet temperature is lower than usual,
• the foam detection security system has been
activated (too much detergent) and the washing
machine has begun draining the foam,
• the out of balance detector has been activated :
an extra phase has been added to distribute
washing more evenly in the drum.
• the water or electricity supply is defective
• a Rinse hold has been selected,
• the drum shutters are open.
• the "immediate opening"
• the temperature inside the drum is too high,
• the lid unlocks 1 - 2 minutes after the end of the
cycle*.
• the lid isn't closed properly.
and
operating problems 43
*
light is not lit,