Selecting A Nose Jaw - Avdel 07271 Betriebsanleitung

SELECTING A NOSE JAW

■
List the name, size and material of the fastener to be placed.
■
Look for this fastener in the first column of the nose jaw selection tables on page 13
if using imperial measurements and on page 14 if using metric units.
■
Looking right across the table, take note of which nose jaws are available. ONLY those
shown are available.
■
Select which is most suitable for your application by referring to the respective nose
jaw drawing. If your application has no access restriction, you should select the
standard shape with a flat end form with or without a cam.
LONG
28.6
1.125
33.5 'D'
1.32
FLAT UNIVERSAL
Available to place most of the fasteners.
Allows more penetration into applications
with no other access restriction.
STANDARD CAM OPERATED
28.6
1.25
34 'D'
1.34
FLAT HEAD FORMING (HF)
Available as shown in NOSE JAW SELECTION TABLE overleaf. Equivalent functions to the Standard, Long and Limited Access above
with the addition of a cam to ease and speed up the nose jaw opening thus the pod reloading procedure.
12
'B'
33.5
1.32
28.6
1.125
'E'
'F'
RIVET
Ø
mm
1
/ .620
8
5
/ .690
32
3
/ .720
16
RECESSED
A v a i l a b l e a s s h o w n i n N O S E J A W
SELECTION TABLE.
Allows more penetration into applications
with restricted access.
Mandrels must be curved by hand to follow
the shape of the jaw.
LONG CAM OPERATED
'B'
'E'
34
1.34
28.6
1.25
LONG CURVED
'B'
'F'
'D'
in.
15.7
17.5
18.3
FLAT RECESSED
'B'
'D'
'E'
FLAT
STANDARD
28.6
1.125
33.5 'D'
1.32
RECESSED TAPERED
FLAT UNIVERSAL
Available in four different end forms to
place all fasteners (except Rivscrew).
Suitable on applications with no or little
access restriction.
LIMITED ACCESS
20.5
0.81
41.4
1.63
FLAT
A v a i l a b l e a s s h o w n i n N O S E J A W
SELECTION TABLE.
A l l o w s a c c e s s i n t o v e r y r e s t r i c t i v e
applications.
LIMITED ACCESS CAM OPERATED
28.6
1.25
37.1 'D'
1.46
FLAT
'B'
'E'
'B'
'E'
'D'
'B'
'E'