Avdel 07271 Betriebsanleitung Seite 42

To reverse the orientation of the cursor, follow these steps:
Item numbers in bold refer to the general assembly and parts list
on pages 25 and 26.
■
Remove tail jaw assembly 1.
■
Pull out mandrel guide 17.
■
Insert a mandrel pointed end first through the rear end of
barrel 59 and push until the mandrel starts appearing at the
front of barrel 59.
■
Pull the mandrel from the front until the cursor falls out.
■
Remove the mandrel and replace the cursor, correct way
round.
■
Replace mandrel guide 17 and tail jaw assembly 1.
L O A D I N G T H E T O O L
The procedure for loading the tool and for fitting the nose equipment to the tool are integral.
When ordering a complete tool or system you will normally be supplied with all the nose equipment required for the fastener to be
placed. To identify nose equipment components or to select the correct elements, read the nose equipment section, on pages 11 to 14.
If you have been supplied with a nose jaw, mandrels and mandrel follower springs proceed with loading the tool and fitting the nose
equipment as follows:
Item numbers in bold refer to the general assembly and parts list on pages 25 and 26.
■
Connect the air supply to the tool or system.
■
Open tail jaws 9 which grip the mandrel, by switching off the tail jaw switch on the hand tools or the pantograph system, (items
53/54 on the 07271 and 07274).
■
Screw selected nose jaws onto barrel 59 of the tool.
■
Insert a mandrel into the tail end of the fasteners through the paper pod.
■
Slide the mandrel follower spring onto the mandrel ENSURING correct orientation, as shown in the table page 9.
■
Gripping the tail end of the mandrel, tear off the paper pod from around the fasteners.
■
Open the nose jaws either by rotating the outer ring on Cam operated nose jaws or by pushing outwards on the jaw ends, as
illustrated top left on page 10.
■
Insert the previously assembled mandrel, mandrel follower spring and fasteners into the nose jaws until the first fastener to be
placed is protuding from the nose jaw.
■
Close the nose jaws and adjust so that the first fastener protrudes by 1.5mm to 3mm (
top right on page 10.
■
Close the tail jaws to ensure the mandrel is gripped.
8
LOADED END
I M P O R T A N T
CURSOR
SPRING
NOSE
JAWS
1 1
/ " to / "), as shown in the illustration
16 8
TOOL
BARREL