Activation Mode For "Alarm Outlet" (3); Restore Factory Settings (Reset) - Renkforce IP65 Bedienungsanleitung

8.7.1 Activation mode for "Alarm Outlet" (3)

You can however activate the alarm outlet in different ways. For this purpose, this code
lock offers you convenient options to specify an activation mode.
Enter the following key combination in programming mode to assign the desired acti-
vation mode:
55 C
C in this case stands for the desired mode type.
Mode types:
C = 0 No function
C = 1 allows the triggering of the alarm outlet in connection with the extended door
monitoring (see chapter: "8.6.2 Setting activation mode for "Aux Out" Relay
Contacts (6)"
C = 2 allows the triggering of the alarm outlet via the sabotage contact.
C = 3 allows mode types 1 and 2 together

8.8 Restore factory settings (RESET)

Proceed in the following sequence:
1) Remove your code lock from the power supply.
2) Move the jumper "Reset" (7) to the position " ".
The two pin contacts on the circuitboard are marked with brace parentheses
and the words "System Restore".
3) Reconnect the operating voltage again.
4) The internal signaller is now active.
5) Move the jumper "Reset" (7) to the position " ".
34