Setting Password For "Aux Out" Relay Contacts (6); Setting Activation Period For "Aux Out" Relay Contacts (6); Setting Activation Mode For "Aux Out" Relay Contacts (6) - Renkforce IP65 Bedienungsanleitung

8.6 Setting password for "Aux Out" relay contacts (6)

The factory setting is no password for "Aux Out" relay contacts (6).
Enter the following key combination in programming mode to assign a new password:
40 HHHH
HHHH in this case stands for the 4 digit combination of numbers you wish to assign as
the desired password.

8.6.1 Setting activation period for "Aux Out" relay contacts (6)

You can specify the activation time of the "Aux Out" relay contacts (i) (to which a door
gong may be connected) yourself. Enter the following key combination while in pro-
gramming mode to do so:
58 TTT
TTT in this case stands for 001 to 999 seconds. If 000 is set, the relay contacts remain
activated until the user password for the "Aux Out" relay contacts is entered again
(=Toggle Mode).

8.6.2 Setting activation mode for "Aux Out" relay contacts (6)

The factory setting is for the "Aux Out" relay contacts (6) to be activated by the pass-
word for the "Aux Out" relay contacts (6).
You can however activate the relay contacts in different ways. For this purpose, this
code lock offers you convenient options to specify an activation mode.
Enter the following key combination in programming mode to assign the desired acti-
vation mode:
57 C
C in this case stands for the desired mode type.
32