Maintenance; Cleaning - Dräger UCF 6000 Gebrauchsanweisung

Malfunction Possible cause
The charging cradle The crawling plate is
LEDs indicate an not positioned
error during the correctly.
charging process or
do not light up at all.
No supply voltage
present
Camera is completely Software malfunction Press the ON/OFF
non-functional (e. g.:
frozen image, camera
does not respond to
pressed keys).
Dräger UCF 6000, UCF 7000, UCF 8000, UCF 9000
5
Remedy
If the camera is used according to the information given in section 2.4
The crawling plate is
on page 34, it does not need to be disinfected. If special incidents
not sufficiently
require disinfection, please contact your local Dräger representative
fastened in place.
for further information.
Retighten screw.
Check and correct
5.1
position of the
Display, viewfinder of the IR camera, viewfinder of the optical camera,
carrying strap.
and the laser window are made from scratch-resistant material.
Carefully clean these surfaces if necessary.
Remove foreign
objects from under
the crawling plate or
!
in the charging cradle.
Place charging cradle
on level surface.
1. Wipe the thermal imaging camera with a damp, lint-free cloth. If
Check operation of
the power supply unit
2. Dry the thermal imaging camera with a soft, lint-free cloth, and
and/or vehicle
connection cable.
3. If moisture has ingressed into the battery compartment, leave the
button for 10 seconds
and switch camera
back on.

Maintenance

Cleaning

CAUTION
Do not use solvents or diluting agents for cleaning the thermal
imaging camera. Otherwise the camera housing could get
damaged.
necessary, clean with warm soapy water.
leave to dry completely.
thermal imaging camera to dry until the contacts are moisture-free.
Maintenance
43