Sound Adjustments; Adjusting The Sound; Using The Sound Control Memory - JVC KS-FX722R Bedienungsanleitung

Adjusting the sound

You can adjust the sound characteristics to your
preference.
1
Select the item you want to adjust.
Each time you press the button,
the adjustable items change as
follows:
BAS
(bass)
VOL
(volume) (loudness)
Indication To do:
BAS Adjust the bass.
TRE Adjust the treble.
FAD* Adjust the front
and rear speaker
balance.
BAL Adjust the left
and right speaker
balance.
LOUD Boost low and high
frequencies to
produce a well-
balanced sound
at low volume
level.
VOL Adjust the volume.
* If you are using a two-speaker system, set the fader
level to "00."

SOUND ADJUSTMENTS

TRE FAD
(treble) (fader)
LOUD BAL
(balance)
Range
–06 (min.)
|
+06 (max.)
–06 (min.)
|
+06 (max.)
R06 (Rear only)
|
F06 (Front only)
L06 (Left only)
|
R06 (Right only)
LOUD ON
|
LOUD OFF
00 (min.)
|
50 (max.)
2
Adjust the level.
Note:
Normally, the control dial works as the volume
control. So you do not have to select "VOL" to adjust
the volume level.

Using the sound control memory

You can select and store a preset sound
adjustment suitable for each playback source
(Advanced SCM).
Selecting and storing the sound modes
Once you select a sound mode, it is stored in
memory. It will be recalled every time you select
the same source and will be shown on the display.
A sound mode can be stored for each of the
following sources — FM1, FM2, FM3, AM, tape
and external components.
• If you do not want to store the sound mode
separately for each playback source, but want
to use the same sound mode for all the sources,
see "To cancel Advanced SCM – SCM LINK" on
page 21.
Select the sound mode you want.
Each time you press the button, the
sound mode changes as follows:
BEAT SOFT
To increase the level.
To decrease the level.
POP
SCM OFF
17