Software License - Sharp AL-2021 Startanleitung

CAUTIONS
Caution label on the unit
The label ( , ) in the fusing area of the unit indicates the following:
: Caution, risk of danger
: Caution, hot surface
Cautions on using
Follow the cautions below when using this unit.
Warning:
• The fusing area is hot. Exercise care in this area when removing misfed
paper.
• Do not look directly at the light source. Doing so may damage your eyes.
• Unit power must be turned off before installing any supplies.
Caution:
• Place the unit on a firm, level surface.
• Do not install the unit in a humid or dusty location.
• When the unit is not used for a long time, for example during prolonged
holidays, turn the power switch off and remove the power cord from the
outlet.
• When moving the unit, be sure to turn the power switch off and remove the
power cord from the outlet.
• Do not switch the unit rapidly on and off. After turning the unit off, wait 10
to 15 seconds before turning it back on.
• Do not cover the unit with a dust cover, cloth or plastic film while the power
is on. Doing so may prevent heat radiation, damaging the unit.
• Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
• The socket-outlet shall be installed near the unit and shall be easily
accessible.
Important points when selecting an installation site
Do not install your unit in areas that are:
• damp, humid, or very dusty
• exposed to direct sunlight
• poorly ventilated
• subject to extreme temperature or humidity changes, e.g., near an air
conditioner or heater.
Be sure to allow the required space
around the unit for servicing and
proper ventilation.
Cautions on handling
Be careful in handling the unit as
follows to maintain the performance of
this unit.
Do not drop the unit, subject it to shock or strike it against any object.
Do not expose the drum cartridge to direct sunlight.
• Doing so will damage the surface (green portion) of the drum cartridge,
causing smudges on copies.
Store spare supplies such as drum cartridges and TD cartridges in a
dark place without removing from the package before use.
• If they are exposed to direct sunlight, smudges on copies may result.
Do not touch the surface (green portion) of the drum cartridge.
• Doing so will damage the surface of the cartridge, causing smudges on
copies.
CAUTION:
Do not install the machine in a location with poor air circulation.
A small amount of ozone is created inside the machine during printing.
The amount of ozone created is not sufficient to be harmful; however, an
unpleasant odor may be noticed during large copy runs, and thus the
machine should be installed in a room with a ventilation fan or windows
that provide sufficient air circulation. (The odor may occasionally cause
headaches.)
* Install the machine so that people are not directly exposed to exhaust
from the machine. If installed near a window, ensure that the machine is
not exposed to direct sunlight.
Supply and Consumables
The supply of spare parts for a repair of the appliance is guaranteed for at
least 7 years following the termination of production. Spare parts are
those parts of the apparatus which may break down within the scope of
ordinary use of the product, whereas those parts which normally exceed
the life of the product are not considered spare parts. Consumables also,
are available for 7 years following the termination of production.
4
20 cm
10 cm 10 cm
In some areas, the "POWER" switch positions are marked "I" and " " on
the copier instead of "ON" and "OFF".
If your copier is so marked, please read "I" for "ON" and " " for "OFF".
Caution!
For a complete electrical disconnection, pull out the main plug.
The socket-outlet shall be installed near the equipment and shall
be easily accessible.
Shielded interface cables must be used with this equipment to maintain
compliance with EMC regulations.
Laser information
780 nm+15 nm
Wave length
-10 nm
Pulse times 12.88 µs ±12.88 ns/7 mm
Output power Max 0.2 mW
At the production line, the output power of the scanner unit is adjusted to
0.18 MILLIWATT PLUS 5% and is maintained constant by the operation of
the Automatic Power Control (APC).
Caution
Use of controls or adjustments or performance of procedures other than
those specified herein may result in hazardous radiation exposure.
This Digital Equipment is CLASS 1 LASER PRODUCT (IEC 60825-1
Edition 1.2-2001)
This product is designed for commercial application only and as such it falls
outside the scope of Regulation (EC) 1275/2008 implementing EU
Directive 2005/32/EC on eco-design requirements for standby and off
mode electric power consumption. Sharp does not recommend the product
for domestic application and will not accept any liability for such use.
Products that have earned the ENERGY STAR
designed to protect the environment through superior
energy efficiency.
The products that meet the ENERGY STAR
shown above.
The products without the logo may not meet the ENERGY STAR

SOFTWARE LICENSE

The SOFTWARE LICENSE will appear when you install the software from
the CD-ROM. By using all or any portion of the software on the CD-ROM or
in the unit, you are agreeing to be bound by the terms of the SOFTWARE
LICENSE.
Trademark acknowledgements
® ®
• Microsoft , Windows , Windows
®
Windows 7 and Internet Explorer
trademarks of Microsoft Corporation in the U.S.A. and other countries.
® ®
• Adobe , the Adobe logo, Acrobat
are registered trademarks or trademarks of Adobe Systems Incorporated
in the United States and other countries.
• IBM, PC/AT, and PowerPC are trademarks of International Business
Machines Corporation.
• Sharpdesk is a trademark of Sharp Corporation.
• All other trademarks and copyrights are the property of their respective
owners.
Do not make copies of anything which is prohibited from copying by law.
The following items are normally prohibited from copying by national
law. Other items may be prohibited by local law.
Money Stamps
Bank drafts Checks
Emission density (measured according to RALUZ122: Edition
Jun.2006)
Measured Condition of
chemicals copier
Ozone
Dust
When copier is in
Styrene
operation
Benzene
TVOC
When on standby
®
are
®
guidelines carry the logo
®
guidelines.
® ®
2000, Windows XP, Windows Vista
®
are registered trademarks or
® ®
, the Adobe PDF logo, and Reader
Bonds Stocks
Passports Driver's licences
Colour mode Diffusion speed
Black and white 1.5 gm/h or less
Black and white 4.0 gm/h or less
Black and white 1.0 gm/h or less
Black and white 0.05 gm/h or less
Black and white 10 gm/h or less
- 2.0 gm/h or less
®
,
TM