Turning Power On/Off; Turning Off The Power - Sharp LL-P202V Installationsanleitung

2. Place the monitor where you want to use it.
Turning on the power
1. Press the POWER button.
The power LED turns on.
2. Turn on the PC.
The screen appears.
Status
Green lit
Orange lit
Alternately flashing red and
green
Caution
• When switching the POWER button off and back on,
always wait for an interval of at least 5 seconds. Rapid
switching may lead to errors or malfunctions.
• High temperatures inside the unit are indicated when the
Power LED is alternately flashing red and green, and may
lead to the power turning off automatically.
• For a complete electrical disconnection, pull out the main
plug.
nOperation Mode
When the monitor is turned on for the first time after being shipped from the factory, the operation mode setting screen will be
displayed. Set it to Mode1 or Mode2.
Mode1......If there is no operation for 4 hours or more, the monitor automatically turns off the power.
Mode2......Will perform standard operation.
Even after being set, changes can be made using [Operation Mode], located in the menu of the monitor. (See OPERATION
MANUAL.)
Installation (Continued)

Turning Power On/Off

POWER button
Press
Power LED
Status of the monitor
Signal input
No signal input
Abnormal temperature
nLL-S242A-W
Horizontal position
Place the monitor on a table or other level surface.
1. Simply lay the unit on the desired location.

Turning off the power

1. Turn off the PC.
2. Depress the POWER button for around 2 seconds.
The power LED turns off.
Caution
• If the monitor will not be used for a long time, disconnect
the power plug from the power outlet.
POWER button
Depress for around
2 seconds
11
E