Declaration Of Conformity; Trouble Shooting - WOLFF CT 200 Originalbetriebsanleitung

Always remove the drum of the CT 200 before working
with the CT 60.

8.0 Trouble shooting

Trouble
Machine does not work
Undue force necessary
Excessive vibration
Handle bar
01/2002 FugBodenfräse CT 200enfräse
7.0
We declare under our sole responsibility that this product is in con-
formity with the following standards of standardization documents:
DIN EN 1037, EN ISO 12100, DIN EN 60204-1, DIN EN 60745-
1, DIN EN 55014-1, DIN EN 55014-2 according to the provisions
of the: 2006/42/EC, 2004/108/EC, 2006/95/EC.
Authorised to issue this declaration and for the gathering of the techni-
WOLFF GmbH & Co. KG | D-74360 Ilsfeld | Ungerhalde 1
Eventual cause
Power supply disconnected
blown fuse
defective cable or plug
Tool is blunt
Expendable parts are
worn out
Lever
Height adjustment hand wheel
On- Off-switch for electric models
Motor
Rear wheel
#013641Fugenfräse FRÄSMASTER

Declaration of Conformity

Dipl.-Ing. (FH) Dieter Hammel
cal documentation.
07.04.2015 i.V.
Elimination
Have machine
repaired by a qualified
electrician
resp. change parts
Change tool
Change tool
Right side plate
Front wheel
12