Setting The Writing Speed - Teac CD Copy Station CD-RT-Standalone/5 Handbuch

3.6 Setting the Writing Speed

The CD-RT-Standalone/5 SLAVE drives are capable of writing
information to a CD or CD-ROM drive at normal (1X), double (2X) or
four times (4X) normal speed. The writing speed is set as described
below. Once the speed is selected, it is used in the CD copying and
testing modes. It has no effect on the compare operations.
1. Press the MODE button until the display shows:
2. Press ENTER.
3. Press the MODE key to cycle between quadruple-speed (4X),
double-speed (2X) and real-time (1X) mode.
4. Press ENTER to confirm the selection.
NOTE
If you are in doubt what speed will work best, pick real-time
first and experiment with the faster settings later. Usually,
however, you should be able to copy most discs at the 4x speed.
50
Cd-rteng.p65
Mode select Mode select Mode select Mode select Mode select
5 Write speed 5 Write speed 5 Write speed
5 Write speed 5 Write speed
Speed select Speed select Speed select Speed select Speed select
4x Write 4x Write 4x Write
4x Write 4x Write
50
3. Modes
10.06.99, 16:41