Teac CD Copy Station CD-RT-Standalone/5 Handbuch Seite 42

sure that the CD-RT-Standalone/5 is not subjected to vibration
or mechanical shocks.
1. Press the MODE key until the display appears as below (the 4x
may also read 2x or 1x, and indicates the speed at which the copy
will be made – see 3.6 „Setting the Writing Speed" below).
2. Press the ENTER key.
3. Place the source disc in the MASTER disc tray, and a blank CD-R
disc in the SLAVE disc tray. If you decide that you do not want to
make a copy at this stage, press the MODE key to return to the
mode selection menu.
4. Press ENTER to start the copy operation. If you have not closed
the disc tray(s), they will close automatically, and the CD-RT-
Standalone/5 will start to read the master disc and check the slave
discs. The words Please wait...
while the discs are checked.
If the CD-RT-Standalone/5 does not detect any potential problems
with the discs, copying will start, and the percentage which has
been written is shown on the display, along with an animated display
to indicate that writing is currently in progress:
5. After the percentage counter reaches 99, the CD-RT-Standalone/
5 writes the TOC to the slave disc, and the display shows:
42
Cd-rteng.p65
Mode select Mode select Mode select
Mode select Mode select
1 Copy 1 Copy
1 Copy 1 Copy 1 Copy
Copy Copy Copy
Copy Copy
Ready ? Ready ?
Ready ? Ready ? Ready ?
Please wait... will appear on the screen
Please wait... Please wait... Please wait...
Writing Writing Writing
Writing Writing
7% 7%
7% 7% 7%
Writing Writing Writing Writing Writing
Finalizing ... Finalizing ... Finalizing ...
Finalizing ... Finalizing ...
42
(4x) (4x)
(4x) (4x) (4x)
(4x) (4x) (4x)
(4x) (4x)
10.06.99, 16:41
3. Modes