Modes; Disc Copy - Teac CD Copy Station CD-RT-Standalone/5 Handbuch

3. MODES

The different modes available are:
– Copy
– Test write
– Compare CD-ROM
– Play audio
– Write speed selection
These are accessed by pressing the MODE key. Details of these modes
are given below.
When the required mode is shown on the top line of the display press
the ENTER key to enter the mode. When the word „Exit" appears on
the display, the ENTER key will halt the current operation.

3.1 Disc Copy

NOTE
You should own the copyright, or have obtained the appropriate
permission from the copyright owner or the rightful licensor,
your unauthorized recording, reproduction or distribution
thereof, may result in severe civil and criminal penalties under
copyright laws and international copyright treaties
This procedure copies the material from the disc (either an audio CD
or a CD-ROM) in the MASTER drive to the CD-Rs in the SLAVE drives.
You may find it useful to test the copy procedure before committing
yourself to an actual copy, however. See 3.2, „Test Write Mode" for
details.
NOTES
Once a copy operation has started, it cannot be stopped before
the disc has been finalized. The only way to stop a copy
operation is to turn off the power to the unit. However, this will
make the CD-R disc useless for any purpose. Do not use
warped discs or discs with off-center holes with the CD-RT-
Standalone/5. While the copy operation is in progress, make
3. Modes
Cd-rteng.p65 41
41
10.06.99, 16:41