Possible Problems When Copying Or In Test Write Mode - Teac CD Copy Station CD-RT-Standalone/5 Handbuch

The display shows the same messages, under the same
circumstances, except that the word Copy
Test in all these messages.
Test Test
Test Test
At the end of the test procedure, the CD-RT-Standalone/5 does
not simulate the writing of the TOC (the finalization process), and
displays:
NOTE
There is one other important difference between test write
mode and copy mode. You can interrupt the test write mode
part of the way through the operation without affecting the
slave CD-R media. If you interrupt a copy procedure part of
the way through the operation, the CD-R becomes unusable.
To interrupt the test write operation, press and hold down the
MODE key. The display will show Exit
press the ENTER key. This cancels the test write process,
and the display returns to the initial status screen. If you press
the MODE key while Exit
returns to the test write display screen.
3.3 Possible Problems When Copying or in Test Write
Mode
If the MASTER or SLAVE drive does not contain a disc, or if the disc
cannot be read by the drive (it is upside-down or badly positioned in
the tray), the display will show No disc
If the SLAVE drive does not contain a recordable CD-R disc, or a CD-
R disc which has been previously partly recorded, the display will show
Bad disc Bad disc
Bad disc Bad disc. Bad disc
The standard maximum length of an audio CD is set at 74 minutes.
However, some commercial CDs are recorded with a running time a
little longer than this. If the master audio CD exceeds 74 minutes in
length (or the standard maximum amount of data (650 MB) for a CD-
44
Cd-rteng.p65
Test write Test write Test write Test write Test write
Finished Finished Finished Finished Finished
Exit. When this is displayed,
Exit Exit
Exit
Exit is shown on the display, the display
Exit Exit Exit
No disc. No disc No disc
No disc
44
Copy is replaced by the word
Copy Copy
Copy
10.06.99, 16:41
3. Modes